EDUCATION REQUIREMENT
Minimum high school diploma

YEARS AND TYPE OF REQUIRED EXPERIENCE FOR POSITION
Minimum 3 yrs experience. Computer skills a plus. SAP and Machine Shop Knowledge/Experience preferred.

Will inspect documentation/part/component/material/subassemblies/equipment against stated specification(s), ensuring that each inspection is done using measurement system with valid calibration and acceptable repeatability and reproducibility – following applicable inspection procedure/Standard Work and ensure compliance against these. • For those conducting manufacturing tests – perform these tests as per their test procedure/Standard Work and ensure compliance against these. • For those conducting engineering tests – conduct the tests as per the test plan, ensuring compliance against it. When necessary, assist in design of tests and fixtures and their set-up. • Ensures all inspection/test activities are conducted in safe manner: participate in creation/review of HARC (Hazard Analysis and Risk Control) for these activities, and ensure a valid one is available prior to conducting the activity. • When authorized, perform calibration of measurement systems following the defined procedure for the activity. • Be familiar with inspection/test procedure/Standard Work or test plan they would carry out; provide input to continuously improve them • Document the results of inspections and tests conducted using the designated business system, following the defined procedure/test plan- including any nonconformance(s) found. Verify stability of result over time (when system to do this is in place).